Hammer Crushers Can Realize the Highest Working Efficiency
2018-05-26 11:03Introduction：Hammercrusherisasingle-stagecrushingmachinethatcandirectlycrushthematerialswhosemaximumgranularityis 600-1800mmto25mmorbelow25mm.Hammercrusherisoneofthemainequipmentsformediumcrushingandfine crushingthemediumhardnessmaterialssuchasmetallur
Hammer crusher is a single-stage crushing machine that can directly crush the materials whose maximum granularity is
600-1800 mm to 25 mm or below 25mm. Hammer crusher is one of the main equipments for medium crushing and fine
crushing the medium hardness materialssuch as metallurgical industry, chemical industry building materials industry and hydropower industry
600-1800 mm to 25 mm or below 25mm. Hammer crusher is one of the main equipments for medium crushing and fine
crushing the medium hardness materialssuch as metallurgical industry, chemical industry building materials industry and hydropower industry
The working principle of our company’s hammer crusher is as follows:
1. The high speed rotary hammer can impact the materials high efficiently and the crusher can be used for the wet and dry crushing processes. The main working part of the crusher is the rotor with the hammerhead which is made up of the main shaft, round disk, pin roll and the hammerhead.
2. The motor drives the rotor to rotate at high speed and the materials enter the crusher from the upper feeding hole. After being impact, cut and ground by the hammer, materials are crushed completely.
3. There is a screening board installed at the bottom of the rotor. Materials with the particle size smaller than the screen holes will be discharged from the screening board. The rough particles will remain on the screen board to be impact and ground again. Then they are also discharged through the screen board.
